It's a cold, damp morning and you notice a misty film on the inside of one of your headlights. Should you be worried?
Often, no. A little condensation in a headlight is normal and clears on its own. But water droplets, standing water or mist that never goes away are a different story. Here's how to tell the difference, and what to do if your headlight is letting water in.
Why headlights get condensation
Headlights aren't completely airtight. They have small vents that let air in and out as the lamp heats up and cools down. When cold, damp air gets inside and the lens cools, moisture can condense on the inside of the glass, just like a bathroom mirror after a shower.
That's why you'll often see a light mist on cold or wet mornings, after a car wash, or after driving through heavy rain.
When it's normal
- A thin, even mist on the inside of the lens
- It appears in cold or damp weather or after washing the car
- It clears within about half an hour of driving with the headlights on
- Both headlights behave roughly the same
Many manufacturers say this kind of light condensation is normal, and it isn't a fault.
When it's a problem
- Large droplets running down the inside of the lens
- Standing water pooling in the bottom of the headlight
- Mist that doesn't clear, even after a long drive
- Only one headlight affected, especially after damage
- Rust or corrosion on the reflector or bulb holder
- Bulbs blowing more often than they should
These point to water getting in, not just normal condensation.
Why it matters
Water inside a headlight can damage the reflector, corrode electrical connections and shorten bulb life. On xenon and LED headlights, it can damage expensive electronics such as ballasts and LED modules. It can also reduce how much light reaches the road and scatter the beam.
At an MOT, the tester looks at whether the lamp works, gives the right beam and isn't seriously defective. Heavy water inside a headlight can affect all of those.
Common causes of water getting in
Missing or loose rear caps
Most headlights have rubber or plastic caps on the back for bulb access. If one is missing, cracked or not fitted properly after a bulb change, water can get straight in. This is one of the most common causes and one of the easiest to fix.
Blocked or damaged vents
The small vents that let the headlight breathe can get blocked with dirt, or their rubber tubes can come off. Without proper airflow, moisture stays trapped inside.
A failed lens seal
The lens is bonded to the headlight housing. Age, heat and car washes can break that seal down, letting water in around the edge of the lens.
Cracks in the housing or lens
A small knock or stone chip can crack the lens or the back of the housing, sometimes in a place that's hard to see.
Broken mounting tabs
Damage to the headlight's mounting points can let it move and stress the housing, opening up gaps.
What you can do
Start with the easy checks. Open the bonnet and look at the back of the headlight. Make sure all caps are present and properly seated, and the vents are clear and connected.
Look over the lens and housing for cracks, and around the edge of the lens for gaps in the seal.
To dry out a headlight, you can remove the rear caps and the bulb, then run the headlights or leave the car somewhere warm and dry so the moisture can escape. Some people use a hairdryer on a low setting through the bulb opening. Don't use high heat, as it can damage the lens and reflector.
If the headlight keeps filling with water, the leak needs fixing. Resealing a lens is possible but fiddly and not always reliable. If the housing is cracked, the reflector is damaged or corroded, or water has damaged the electronics, replacing the headlight is usually the best fix.
If your lens is also cloudy or yellowed on the outside, our guide to cloudy headlights explains whether to restore or replace.
Finding a replacement headlight
Headlights are specific to the make, model, year and trim, and many cars have halogen, xenon and LED versions that aren't interchangeable. Our guide to halogen, xenon and LED headlights explains how to tell which you have. The safest way to get the right one is to match the part number on the back of your old unit. If you're not sure, send us your VIN and we'll help you find the right one.
We stock thousands of replacement headlights for most popular makes in our lighting range. After fitting a new headlight, have the aim checked. Our guide on how to adjust your headlights shows how.