Three headlight units displayed side by side on a workshop bench, comparing warm halogen, xenon projector and modern LED designs.

Halogen vs Xenon vs LED Headlights: What's the Difference?

Look at the front of cars on any UK road and you'll see three kinds of headlight. Older cars have a warm yellowish glow, many mid-2000s cars have a crisp bluish-white light, and newer cars have bright white LED strips and lenses.

Those are halogen, xenon and LED headlights. They work in very different ways, and that matters when one fails, when you want to upgrade, and when your car goes in for its MOT. Here's what you need to know about each.

Halogen headlights

Halogen bulbs work like a traditional light bulb. A tungsten filament glows when electricity passes through it, inside a glass capsule filled with halogen gas.

They're the oldest of the three and still fitted to many cars, especially lower trims. Common bulb types include H1, H4 and H7.

The good points are that halogen bulbs are cheap, easy to replace and widely available. The downsides are that they give a yellower, dimmer light than the alternatives, use more power and don't last as long.

Xenon (HID) headlights

Xenon headlights, also called HID or high intensity discharge, don't have a filament. Instead, an arc of electricity jumps between two electrodes in a capsule of xenon gas, which produces a very bright, white light with a slightly blue tint.

They need a ballast, a control unit that delivers a very high voltage to start the arc. You'll often notice that xenon headlights take a few seconds to reach full brightness after switching on. Common bulb types include D1S, D2S and D3S. Bi-xenon headlights use one bulb for both dipped and main beam, with a moving shield inside the headlight to switch between them.

Xenon lights are much brighter than halogen and last longer. They're more expensive to replace, though, and the high voltage means they need care when working on them. Faults can come from the bulb, the ballast or the igniter.

Under MOT rules, cars with HID headlights fitted from new and first used from September 2009 need working headlight washers if they were fitted, and any self-levelling system fitted must work. For more on the beam check, see our guide on how to adjust your headlights.

LED headlights

LED headlights use light-emitting diodes, the same technology as many household bulbs. They're now standard on many new cars.

LEDs give a bright, white light, switch on instantly, use little power and can last a very long time. They also let manufacturers design slim, distinctive headlights, and many use clever features such as adaptive matrix beams that shade out oncoming traffic.

The catch is that on most cars, the LEDs are built into the headlight unit. There's no bulb to swap. If an LED module fails, it often means replacing the whole headlight or a specific module, which can be expensive.

Which is best?

For light output, LED and xenon both outperform halogen by a wide margin. LEDs have the edge on efficiency and lifespan, while xenon still gives a very good spread of light. Halogen wins on purchase and replacement cost.

In practice, you can't usually choose. Your car will have whatever type it was built with, and the headlight unit is designed around that light source.

Can you upgrade halogen to LED or xenon?

This is where many people get caught out. Aftermarket LED and HID conversion bulbs are widely sold, but a halogen headlight's reflector and lens are designed for a halogen filament. Putting a different light source in can scatter the light and dazzle other drivers.

Under the MOT rules for cars first used from 1 April 1986, a halogen headlight converted to HID fails. An LED replacement bulb in a halogen unit also fails unless it's approved for that specific headlight and carries the matching approval marking. Our earlier guide on factory LED headlights vs LED bulb conversions goes into more detail.

If you want xenon or LED light, the proper route is a complete headlight unit designed for that light source, fitted to a car that supports it.

How to tell which you have

Check your handbook or the label on the headlight. You can also look at the light itself: a warm yellowish light is usually halogen; a bright bluish-white light that takes a moment to reach full brightness is usually xenon; instant crisp white light from strips or small lenses is usually LED. Headlight part numbers and descriptions also often state the type, such as "Bi-Xenon" or "LED".

Replacing a headlight

Many cars came with more than one headlight option depending on trim, so the same model might have halogen, xenon or LED versions that aren't interchangeable. The safest way to get the right one is to match the part number on the back of your old headlight. If you're not sure, send us your VIN and we'll help you find the right one.

We stock hundreds of xenon headlights and LED headlights, as well as xenon ballasts, in our lighting range. If your headlights are looking tired, our guide to cloudy headlights explains when to restore and when to replace.