Anodes are some of the cheapest parts on a boat, and some of the most important. Those dull lumps of metal on the outboard leg, the shaft or the transom are there to be eaten away, so your engine, propeller and stern gear don't get eaten away instead.
The catch is that the right anode metal depends on the water you keep your boat in. Here's how anodes work, which metal to choose, and when to change them.
What does a sacrificial anode do?
When two different metals sit in water and are connected electrically, they form a simple battery. The less "noble" metal slowly corrodes, protecting the more noble one. This is called galvanic corrosion.
An outboard or sterndrive has aluminium housings, stainless or bronze parts and steel fasteners, all in the water together. Without protection, the aluminium leg and other parts would start to corrode. A sacrificial anode is made from a metal that's even less noble, so it corrodes first and takes the damage instead.
That's why a wasting anode is a good sign. It means it's working.
Zinc, aluminium or magnesium?
Salt water
Zinc has been the traditional choice for salt water for many years. Aluminium anodes, made from a special alloy, are now widely used in salt water too. They give good protection, last well and also work in brackish water. Many outboard manufacturers now fit aluminium anodes as standard.
Brackish water
For estuaries and harbours where fresh and salt water mix, aluminium is usually the best choice. Zinc can stop working properly in lower salt levels, as it can build up a crust that stops it corroding.
Fresh water
Magnesium is the most active of the three, and it's the right choice for fresh water, where zinc and aluminium don't give enough protection. Don't use magnesium in salt water. It will be eaten away very quickly and can over-protect the boat, which can damage paint and some metals.
Moving between waters
If you trail your boat between fresh and salt water, aluminium is often the best all-round compromise. Check your engine maker's advice.
Never mix anode metals on the same boat. Use one type throughout.
When should you change anodes?
The common rule is to replace an anode when it's about half wasted away. Check them at least every season, and more often if the boat stays in the water.
Change them sooner if:
- They're crumbling, badly pitted or loose on their mounting
- They're covered in a hard white or grey crust and not wearing at all, which can mean the wrong metal for your water
- You've moved the boat to a different type of water
If anodes are disappearing unusually fast, there may be an electrical problem, such as a leaking wire or faulty shore power connection. That's worth getting checked, as it can damage the boat quickly. Our guide to boat electrics basics covers the essentials.
Fitting tips
- Never paint anodes. Paint stops them working completely
- Make sure the mounting surface is clean bare metal, so there's a good electrical connection
- Use the correct fixings and don't use thread lock or sealant that could insulate the anode
- On outboards, check all the anodes, not just the obvious one on the leg. There are often more on the transom bracket, the trim tab and inside the engine
Checking anodes is a perfect job for your annual service. Our outboard maintenance checklist lists what else to look at, and our guide to choosing an outboard propeller is handy if your prop needs attention too.
Outboard and marine parts
Anodes are specific to the engine model and position, so take the part number from your old anode or your engine manual. You'll find a range of outboard engine parts and other marine parts in our marine range. If you're not sure what fits, send us your engine make, model and serial number and we'll help you find the right one.