You've swapped your car's old orange indicator bulbs for bright LED ones. They look great, but now they flash twice as fast as they should, and maybe there's a bulb warning on the dash too. That's hyper flash, and it's one of the most common side effects of fitting LED indicator bulbs.
Here's why it happens and the ways to fix it. If you ride a bike, we've also got a guide to LED indicators and hyper flash on motorbikes.
Why LED indicators flash fast
A standard indicator bulb draws about 21 watts. An LED replacement might draw only two or three. The car notices that drop in current.
On older cars, the flasher relay is designed around the load of normal bulbs. With much less load, it flashes faster. On newer cars, the body control module watches the current in each indicator circuit. When it sees very little current, it assumes a bulb has blown and deliberately speeds up the flashing to warn you. Many cars also show a bulb failure message.
So the car isn't broken. It's doing exactly what it was designed to do when a bulb fails.
Is hyper flash a problem?
Yes. Other drivers read a fast flash as a fault, and the MOT checks that indicators flash at between 60 and 120 times a minute. A car that hyper flashes is likely to fail. A bulb warning on the dash is also annoying to live with.
How to fix hyper flash
Load resistors
The most common fix. A load resistor is wired in parallel with each LED bulb and draws extra current, so the car sees roughly the same load as a normal bulb and flashes at the right speed.
Load resistors get very hot, because that extra current is turned into heat. Mount them on bare metal, away from plastic trim, wiring and anything that can melt. Use proper connectors rather than twisting wires together. You need one resistor for each LED indicator bulb.
LED-compatible flasher relay
On older cars with a separate plug-in flasher relay, you can sometimes swap it for an electronic relay designed for LEDs. That fixes the flash rate without resistors. It won't help on cars where the body control module handles the indicators, which covers most modern cars.
CANbus LED bulbs
Some LED bulbs are sold as "CANbus" or "error free". They have a resistor or decoder built in. They're tidier, but they can run hot and don't work on every car. Check reviews and compatibility for your model.
Coding
On some cars, the bulb monitoring can be adjusted with a diagnostic tool so the car expects LEDs. This depends on the make, and it can switch off useful bulb failure warnings.
Other things to check
- Use the right colour. Indicators must show amber light, so clear lenses need amber LED bulbs
- Check the bulb fits the holder properly and doesn't touch the lens
- Make sure the light is bright enough and visible from the right angles
- Do one side, test it, then do the other, so you know the fix works before buying more parts
An LED bulb in a lamp designed for a normal bulb won't always give the same light pattern. A complete LED indicator or rear light unit made for your car avoids that problem.
What we stock
We stock a set of four LED indicator load resistors (50W, 6 ohm), which is one for each corner of most cars. We also have complete LED rear lights and indicators for many popular cars in our lighting range.
Light units are specific to the make, model and year, so match the part number on your old unit. If you're not sure, send us your VIN and we'll help you find the right one.
Thinking about LED headlights too? Read our guide to factory LED headlights vs LED bulb conversions first.